| Footprint size, weight | 2300W x 700D About 500Kg |
| Applicable warp | AWG#28 ~ #20 |
| Wire feed mode | Stay wire |
| Wire length | 40 ~ 1000mm(long line needs to be equipped with conveyor belt) |
| Stripping length | The first side is 1.0 to 8mm, and the second side is 1.0 to 10mm |
| Holding capacity | 1.5T servo terminal machine (2 sets) |
| Crimping terminal | JAM type cross feed terminal (JST, Molex applicable, need to replace the punch and base plate can be good) |
Suitable for rubber seat dimensions | 58W x 20D x 15H |
| capacity | 2.8sec/ piece (when the length of the wire is less than 50mm) |
| Peeling method | Reverse screw |
| Handling mode | Linear motor, a total of two trolley clips, high position accuracy |
| Assembly mode | Sequential assembly |
| Quality inspection function | End vision monitoring, terminal vision monitoring, pressure monitor, assembly in place monitoring |
| Rubber seat feeding method | Vibrating disk feed |
| Operating station | Six stations + two carts |
| Air pressure requirement | 0.5 to 0.7MPa |
| Power interface | 220V |
| The number of shafts of the feed rack | 8-axis |
0086 13549921807
